- Verified Buyer
Q: Should the bowden tube come out so easily? I'm finding lots of printing errors due to it not holding on.
A: The Bowden tube should not be coming out of the collet very easily. Please make sure the Bowden tube is secured and the collet clip has been attached. Also, please make sure the OD of the Bowden tube is not smaller than 4 mm.
Q: I got a bondtech set up e3d v6 with this adapter let use bondtech housing with mosquito hotend
A: Yes, the Mosquito Hotend used with the Groove Mount Adapter will be a direct substitution for the Bondtech extruders with groovemount setup such as the Bondtech BMG.
Q: Is this the same groove profile as the E3d v6?
A: Yes, the Groove Mount Adapter has the same profile as standard groovemount hotends such as the E3D V6.
Q: Is this adapter also compatible with the Mosquito Liquid?
A: Yes, the Groove Mount Adapter is compatible with the Mosquito Liquid. The only difference is that you will need longer M2.5 screws for the adapter anywhere from 12 to 14mm in length.
Q: What size it the threaded mounting hole? M2.5 .45 pitch? Thank you
A: That's correct! The threaded mounting holes for the Groove Mount Adapter are M2.5 x 0.45 with a minimum depth of 5 mm.