Mosquito® Magnum Hotend Bundle
- Mosquito® Magnum Hotend
- Bondtech DDX For Creality 3D Printers
- Adapter Set For Creality Ender / CR-10
- DDX Hotend Adapter - Mosquito®
- Thermistor: High Temperature - 300°C
- 50W Heater Cartridge (Voltage: 24V)
- Nozzle Torque Wrench™: 1.5 Nm
- Vanadium™ Nozzle (0.4 mm)
- Plastic Repellent Paint™
- Boron Nitride Paste
Check out the newly updated Mosquito®! Now with a coated heat break!
- The Mosquito® Magnum prints upwards of 30 mm^3/sec
- A thermal insulator protects the extended melt zone from the effects of active cooling and radiative heat loss. It has a heat transmission rate as low as 3 W/m*K, meaning you can have ultimate confidence in the speed of your print, while at the same time maintaining the high resolution benefits achieved with the standard Mosquito® Hotend
- The melt zone is extended proximally upwards to maintain a small form factor
- Included thermistor covers printable thermoplastics up to 300°C
- Modular/adaptable to almost any FFF/FDM printer
- Note 1: For installation instructions and other important information related to the DDX upgrade, click here.
- Note 2: If you do not want to use the DDX, you can try to print your own adapter by clicking here.