Product Specifications

Most recent update: October 26, 2021

Category	Copperhead, Mosquito, Mosquito Magnum	Mosquito Magnum+
Sockets available for temperature sensor installation	1x socket for a Ø3 sensor of length 15-22mm	2x sockets for Ø3 15mm-long sensors
Sockets available for heater installation	1x socket for a Ø6 22mm-long heater	2x sockets for Ø6 22mm-long heaters
Standard Heating Power: Configuration	1x 50W heater	1x 50W heater
Standard Heating Power: Total power output	50W	50W
Maximum Heating Power: Configuration	Not applicable	2x 50W heaters
Maximum Heating Power: Total power output	Not applicable	100W
Maximum allowable continuous-use operating temperature (3 months)	450°C * Maintaining this temperature while printing requires a heated build chamber * Silicone Boot accessory shall not be used above 290°C	450°C
Maximum allowable momentary operating temperature (30 minutes)	500°C * Maintaining this temperature while printing requires a heated build chamber * Silicone Boot accessory shall not be used above 290°C	500°C
Nozzle compatibility	RepRap-pattern nozzles with 7mm thread length * 6mm hex is required for compatibility with Silicone Boot accessory	RepRap-pattern nozzles with 7mm thread length * 6mm hex is required for compatibility with Nozzle Insulator accessory
Compliance with standards concerning materials used in the products	RoHS, REACH	RoHS, REACH