👉 Now Offering FREE Shipping & FREE Returns
See terms for details.

Product Specifications

 

Most recent update: October 26, 2021​
Category Copperhead, Mosquito, Mosquito Magnum Mosquito Magnum+​
Sockets available for temperature sensor installation 1x socket for a Ø3 sensor of length 15-22mm 2x sockets for Ø3 15mm-long sensors
Sockets available for heater installation 1x socket for a Ø6 22mm-long heater 2x sockets for Ø6 22mm-long heaters
Standard Heating Power:
Configuration
1x 50W heater 1x 50W heater
Standard Heating Power:
Total power output
50W 50W
Maximum Heating Power:
Configuration
Not applicable 2x 50W heaters
Maximum Heating Power:
Total power output
Not applicable 100W
Maximum allowable continuous-use operating temperature (3 months)

450°C
* Maintaining this temperature while printing requires a heated build chamber
* Silicone Boot accessory shall not be used above 290°C

450°C
Maximum allowable momentary operating temperature (30 minutes)

500°C

* Maintaining this temperature while printing requires a heated build chamber
* Silicone Boot accessory shall not be used above 290°C

500°C

Nozzle compatibility

RepRap-pattern nozzles with 7mm thread length
* 6mm hex is required for compatibility with Silicone Boot accessory

RepRap-pattern nozzles with 7mm thread length
* 6mm hex is required for compatibility with Nozzle Insulator accessory

Compliance with standards concerning materials used in the products

RoHS, REACH

RoHS, REACH