
Use this thermistor with the HeatLink plug and play connectors to upgrade your 3D printer with no hassle. Scroll down below to check if your printer has a plug and play connector.
Which Thermistor Interface Cable Is Compatible With Your 3D Printer?
Plug & Play Thermistor
- 1.5m leads with blue sleeves and Molex micro-fit 3.0 female connector
- Ø 3mm Stainless Steel crimped cartridge with laser engraved Bondtech logo
- SeMitec 104NT-4 temperature sensor
- Packed in plastic bag
Bondtech HeatLink Thermistor
This 300 °C thermistor, based on the SeMitec 104NT-4-R025H42G temperature sensor, uses a Molex micro-fit 3.0 female connector to enable extending it with one of the HeatLink interface cables so you can connect it to your printer without hassles.
Use the following code to customize your Marlin2.0 to use this thermistor:
#define TEMP_SENSOR_0 5
Check the R/T table here:
104NT-4-R025H42G_RT_table.pdf
HeatLink is the answer to the growing demand for powerful heaters and high temperature thermistors that are ready to use and easy to install (no more soldering and crimping). HeatLink is ready to use on (at least) 25 different Creality and Prusa models. Each Interface Cable is 50 mm long and will fit entirely inside the control box.
Technical Specifications

